Distance Charge

The distance charge feature automatically adds fees to work orders based on the distance between a customer's location and your service location.

Configuration Options

Mode

  • Disabled - No mileage charges are applied
  • Enabled - Mileage charges are calculated automatically based on configured ranges

Mileage Ignored

Specifies the number of kilometers to exclude before range calculations begin.

Range Pattern

The pattern follows this syntax:

start-end:cost[,start-end:cost...]

Where:

  • start = Range beginning (in km)
  • end = Range ending (in km)
  • cost = Price (use $ prefix for per-km rates, omit for fixed amounts)

Fixed-Rate Example

For a flat $40 charge on trips of 0–25 km:

0-25:40

Per-Kilometer Example

For $1.50 per km on trips of 0–25 km:

0-25:$1.50

Multiple Ranges Example

To set free service for 0–25 km, $1.50/km for 26–50 km, and a flat $200 for 51–75 km:

0-25:0,26-50:$1.50,51-75:200

Note: When ranges overlap, the first matching range applies.

Multiple Ranges with Ignored Mileage

The ignored mileage reduces the total distance before range matching. For example, with 65 km total distance and 25 km ignored mileage, the effective distance becomes 40 km, which may fall into a lower rate bracket.

Journey Calculation

Choose how distance is measured:

  • One Way - Distance from location to customer only
  • Return - Distance from location to customer and back

Optional Charges

  • No - the distance charge is always added
  • Yes - the New Work Order form asks Does the customer require the unit to be collected and delivered? The distance charge is added only when the answer is Yes. The answer starts as No

Option Prompt

Not currently used. The question above is always shown.