Fault Codes
Overview
Fault codes record what was wrong with a product and what was done about it. They are kept in three levels: a fault area (the part of the product), the symptoms an area can show, and the actions that can be taken for a symptom. A work order's fault is recorded as an area, a symptom and the actions taken, so reports can read consistently across technicians.
The page
Administration > Service & Faults > Fault Codes shows the three levels side by side. Click an area to list its symptoms, and a symptom to list its actions; the first row of each list is selected when it loads. Each list has a search box.
Areas and symptoms
- New Fault Area and New Fault Symptom open a form with the name. A symptom is created under the area selected at the time.
- The edit icon on a row opens the same form. Delete, at the left of the form, is available while nothing refers to the record: an area with symptoms or product types tied to it, or a symptom with actions, products or group schemes tied to it, keeps Delete disabled and the tooltip says what uses it. Merge it instead.
- The merge icon on a row merges that area or symptom into another: choose the area or symptom to merge it into under Merge Into (for a symptom, its area and then the symptom) and press Merge. Everything recorded against the original moves to the target, including closed work orders, and the original is deleted. This cannot be undone.
Actions
The Fault Actions list is the whole list of actions, with the ones that apply to the selected symptom ticked and shown in bold.
- Tick the actions that apply to the selected symptom and press Save. With none ticked, every action is available for the symptom.
- New Fault Action adds an action; the edit icon on a row renames it and the delete icon removes it from every symptom it is ticked for.